Garage Door Not Working? What It Means and When to Call
Usually it's the sensors, a broken spring or a door off its track. Stop using the door if a spring or cable is broken. At Santos & Sons in Berkeley, sensor repair runs $100 to $250 and a single torsion spring $195 to $425, 8 AM to 8 PM, seven days a week. Call (650) 750-7029.
Jump to Your Symptom
- Won't Close
- Won't Open
- Opens, Then Reverses
- Goes Down, Then Back Up
- Opens by Itself
- Opener Hums but the Door Doesn't Move
- Loud or Grinding Garage Door
- Is Off Its Track
- Car Stuck Inside the Garage
Garage Door Won't Close
Check the lock button on the wall control and the remote battery first. If the opener light blinks and the door won't go down at all, the sensors at the bottom of the tracks can't see each other. Our guide to a blinking sensor light walks through the fixes.
Stop if the door hangs crooked or a cable is loose.
Related service: Sensor repair.
Garage Door Won't Open
Check the lock button on the wall control and the opener's power first. If the opener runs but the door stays down, a spring has usually broken.
Stop using the door if you see a gap in the spring coil.
Related service: Spring replacement.
Garage Door Opens, Then Reverses
Usually the safety sensors: a lens is dirty, bumped out of line or in direct sun. Less often the close force is set too low or a roller is binding.
Stop using the door if a cable is loose or the door hangs crooked.
Related service: Sensor repair.
Garage Door Goes Down, Then Back Up
If it touches the floor and rises again, the close limit is set too far or something sits under the door. If it turns around partway with nothing in the way, the force setting needs adjusting or the door has become heavy.
Stop if the door feels heavy when you lift it by hand.
Related service: Opener repair.
Garage Door Opens by Itself
Usually a stuck wall button, a remote pressed inside a bag or a pocket, or a worn logic board sending its own signal.
Unplug the opener until it's checked if it keeps happening.
Related service: Opener repair.
Opener Hums but the Door Doesn't Move
The motor runs but the drive doesn't: a stripped gear, a trolley that came off, or a door too heavy to lift because a spring broke.
Unplug the opener so the motor doesn't burn out.
Related service: Opener repair.
Loud or Grinding Garage Door
Grinding and rattling usually come from worn rollers, dry hinges or loose hardware. A single loud bang followed by a heavy door is a spring.
Stop using the door after a loud bang from the garage.
Related service: Roller replacement.
Garage Door Is Off Its Track
Rollers have left the track, often after the door hit something. Don't try to force it back.
Stop using the door until it's back on its track.
Related service: Off-track repair.
Car Stuck Inside the Garage
With the door closed and the opener not lifting it, the emergency release lets you open it by hand, as long as the springs are intact. The steps are on our emergency repair page.
Don't pull the release if a spring is broken. The door can drop.
Related service: Emergency repair.
What a Visit Includes
- We find the cause and show it to you.
- You get the price in writing before any work starts.
- We fix it, test the door and clean up.
Common Questions
Why won't my garage door close?
Most often the safety sensors can't see each other: a dirty lens, a bumped bracket or low sun. The lock button and the remote battery are the next things to check. If the door still won't close, call (650) 750-7029.
Why does my garage door go back up before it closes?
Usually the safety sensors: something breaks the beam, or a lens is dirty or out of line. If the sensors are clear, the close force or the travel limit needs adjusting. Call (650) 750-7029 if wiping the lenses doesn't fix it.
Is it safe to keep using a door that isn't working right?
If a spring or cable is broken, no: leave the door closed. A noisy or slow door can be used carefully until the repair, but each cycle wears the other parts.